Matching motor duty, the command voltage and auxiliary feedback when ABB AF30-30-00-13 is specified for an existing starter
ABB AF30-30-00-13 is an AF-series three-pole contactor with a 100–250 V AC/DC control circuit. ABB lists product identifier 1SBL277001R1300. For a motor starter purchase, the relevant comparison includes utilization category, motor voltage, operating duty and the complete protection assembly; a single current figure does not describe every possible switching application.
Contactor details that anchor the comparison
| Selection item | Verified information or configuration check |
|---|---|
| Exact model | ABB AF30-30-00-13 |
| ABB identifier | 1SBL277001R1300 |
| Main contacts | 3 normally open poles |
| Control supply | 100–250 V AC at 50/60 Hz, or DC |
| Base auxiliaries | 0 NO and 0 NC |
| Published motor duty | 15 kW AC-3 at 400 V |
| Connections | Screw terminals; check conductor requirements |
Two voltages on one order
Specify both motor supply and coil supply for ABB AF30-30-00-13. These are different circuits and need their own checks against the panel drawing. The wide coil range does not establish the suitability of the main poles for an arbitrary load. Include the actual control source and whether an interposing device is present. A procurement comparison should keep those facts on separate lines so a coil suffix cannot be overlooked.
Shared reference image associated with ABB AF30-30-00-13; it does not establish the exact delivered model, options or accessories.
Start with the load history
- A useful inquiry for ABB AF30-30-00-13 includes the motor nameplate and the expected start frequency.
- Describe reversing, jogging or other duties that differ from ordinary starting.
- Have the responsible panel engineer choose the applicable manufacturer rating for those conditions.
- If the previous contactor failed, attach the findings about connections and load behavior; ordering the same reference alone does not establish why the earlier unit was damaged.
Feedback contacts are separate scope
The listed base version of ABB AF30-30-00-13 has no auxiliary contacts. Identify every status or interlock contact used by the existing circuit and list the required accessory separately. Check accessory compatibility against ABB documentation and the available mounting space. This is especially relevant when a spare is taken from a warehouse where the old assembly included accessories that were never recorded on the original purchasing line.
Coordinate the starter assembly
Review ABB AF30-30-00-13 with the overload and short-circuit protection selected for the starter. The component order should reference the approved assembly rather than invent a protection combination. Record enclosure conditions, connection hardware and the existing drawing revision. For replacement planning, compare the terminal arrangement and access for tightening before treating a matching footprint as sufficient evidence of a complete mechanical fit.
Inspect the offered unit
For ABB AF30-30-00-13, obtain label details and a clear statement of whether the offer is the bare contactor or an assembled kit. Other AF30 coil versions and larger AF contactors may appear in supplier searches, but their differences require review.
Keep condition, quantity and included auxiliary blocks explicit. Use the purchase reference for ABB AF30-30-00-13 again on the receiving record so the warehouse can reject an unexplained suffix change.
